Abit FX5600 OTES Manual de usuario descargar pdf (Pagina 24)

MAG

If your rack ha

s holes too large for the

screws, you can use the Bar Nut to

secure your mounting by inserting the

Panhead screw through the rack hole

and screwing it into the Bar Nut on the

reverse side of the rack post, as shown:

NOTE

Notice that the holes on the Bar Nut are spaced unevenly to

accommodate different racks.

The EB2 chassis requ

ires two

extender brackets (supplied with

the rack-mounting kit) be installed

on one side of the chassis in order

for the chassis to fit widthwise in a

standard rack.

The extender brackets should be

attached in-between the Bar Nut

and the Panhead screws as

shown:

Extender

bracket

Attach Slide Rail to Rack

Attach the othe

r side of the rack with “fingers” pointing “out” and the end

bracket to the rear. Secure each Slide Mount with 4 screws as shown

below.

Secure the slide rail to the

rack with 2 screws to both

front and rear posts. After

you have secured the slide

rail fingers to the rack posts,

tighten the 2 screws used to

attach the slide rail to the end

bracket.

中国总代理长沙鹏翔

全国服务热线：4006-010-842

长沙鹏翔电子科技有限公司

地址：长沙高新区文轩路27号麓谷企业广场A4栋507

网址：http://www.ndttech.net

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 73 74

Sin comentarios

Abit FX5600 OTES Manual de usuario Pagina 24